E-Projects 10EP5122K20 2.2k Ohm Resistors, 1/2 W, 5% (Pack of 10)

I used this resistor to bypass an oxygen sensor on one of our automobiles, following a performance modification. It works perfectly. No more check engine light and the engine runs correctly now. The leads tin up well, using ordinary electrical solder, and the value markings are clear and permanent.Good purchase...

They work as they should. Well made. Rated for 1/2 watt make sure you are aware. The wire is quite thin.

These worked great for my need. Nicely packaged and fixed the problem I was having with the key pass on a Chevy express.

Use it to add power to a tach signal wire. Worked perfect

Was recommended to use this when doing the catless up pipe upgrade in my 2002 Wrx.In theory it should keep the check engine light away since you are removing a whole sensor in the exhaust.So far I’d say it works, I have not seen any check engine lights, car runs perfect, no limp mode or anything. Driven the car about 200+ miles with the resistor mod so far.Used a rubber glove thumb to cover the open wiring where the original sensor was unplugged.Though I have not tried it without the resistor mod. So, I wouldn’t know if there is or is not a check engine light that comes up.There’s been some debates on old forums if it does or not so, I’m not sure. But I played it safe and grabbed these.