Creative Hobbies 5 Inch (130mm) DIY Snow Globe Water Globe - Clear Plastic with Screw Off Cap | Perfect for DIY Crafts and Customization

This size is perfect for my souvenir apple from the Sphere. Love it! The apple fits in the 4” but visually looks better in the 5” 😍

Perfect

Got this to use for a crystal ball project and it was the perfect size

Item is nice. Exactly what I was looking for, except the outer cap for mine doesn't screw on correctly and caused it to leak but otherwise nice item.

This was great to make a snow globe with my daughter. The only thing is it did leak just a tad but I hot glued the seal afterward before screwing the final top on and that did the trick! I would definitely get more and just do this extra step for peace of mind. Some diy videos I found did and didn’t glue the seal, which is why I tried our snow globe without glue but was cautious to check for leaking afterward. The globe part is very thick and has held up against my 8 year old’s frantic shaking!!

Worked great to replace a glass snow globe that had become bad inside. Easy to use.

I think the base is too narrow. It looks like an oddly shaped lightbulb. Don’t square the round part too hard because it gets dented. I made this snow globe for my son. I used sandpaper to sand down the base and figurines, E6000 glue to glue the snowman and tree, distilled water, two tablespoons of vegetable glycerin, clear glitter, and silver glitter, silicone sealant to seal it, and thread seal tape to seal it even more. After having yo purchase all of those things mentioned above, I realized I could have bought a snow globe from the Disney Store for almost the same price.

This is just what I needed. One of my ceramic students wants to handbuild a replica of a gumball machine, but needed a clear sphere that was big enough for clay balls to go in, and also had the opening with the threads, so she could build a lid for the top. We will glue the sphere to the base after it has been fired. The thick plastic seems sturdy.

The instruction sheet, such as it is is pretty useless, using code numbered products to do the job. The plastic stopper didn't stick properly to my ornament, it fell off inside the globe, the glue had not adhered to the plug despite roughing it up as suggested. Next problem, the stopper was very reluctant to go into the globe because as I pushed it in, the air pressure inside the globe kept pushing it back out again; this happened repeatedly until my ornament fell off inside the globe, leaving me a horrible mess to clean up. Regret buying this especially with it being very expensive too. I should have bought one of those photo snow globes, it would have done a reasonable job without all the faff and mess and a lot cheaper. I'm going to have to redesign how this globe goes together and use other techniques for assembly so you can actually assemble it and it remains intact and doesn't leak.