DancoComplete Faucet Rebuild Trim Kit for Delta Faucets, Acrylic, 1 Kit (39675)

I really only needed a washer set, but, it was to cheap to not get the whole replacement set. the handles are slightly smaller than Delta originals, other than that, fit and finish is really superb.i only notice one quirk, you can turn the water on high flow, or low flow, or off, not just slowly adjust from off to high.cant say that is a bad thing or good thing, just an " odd/different" thing. would NOT keep me from buying from them again, should I need to replace other faucets in my 3 other bathrooms.i cant speak for longevity, as its only just been replaced, but, FOR the money.. its 5 stars..had no issue with fit, no problems really other than i had to use my old screws from my delta handles, as the new ones were too long.not a gripe, just observation. and again, my tub is 20+ yrs old ( maybe 30, actually, but not sure, not the original owner ). it works, hot and cold both replaced, cost compared to others was VERY modest.definitely buy again.

I didn't realize that it made the faucet full-open in one-quarter turn. Adding a piece to prevent the user from turning the faucet further than 90 degrees would be useful.

Bought this kit to repair our leaking Delta Delex kitchen faucet. Upon installation, the faucet stopped leaking, but... a new leak occurred from the cold-side handle. I swapped the stems and the leak followed to the hot-side handle.Rather than going through the hassle of a refund, I contacted the seller, Jenco Wholesale Inc. They promptly sent me a new set of stems and washers, at no charge. Installation of the new stem was a success. Finally, no more leaks!Overall the kit is ok. I mean, it did the job, eventually. The handles look like the originals, but as other reviewers pointed out, the flow is a bit weird. Maximum flow is at about 3/4 turn of the handle, then declines toward full open.Installation was pretty straightforward. Just search Youtube for instructions, like I did before purchasing. If you get a bad part, it happens. Just contact the seller, they will likely make it right.Product: 3 starsSeller: 5 starsReview: 4 Stars

I am a tenant and just not that great at home repairs but also responsible for minor maintenance. I was trying to remove my faucet handles to clean the hard water crusties and cracked one. I was having a hard time finding the same kind for the older faucet and these looked the same. Sure enough they fit perfectly. I did tighten them one turn too tight and had to loosen them. No complaints with the product and easy install.

I bought these in January of this year to have on hand as I have 3 faucets that use these cartridges. This morning I had to replace a leaker and proceeded with the installation:Pros: Cartridge fit well and operates smoothly. I especially like the stainless steel stem and matching machine screw to attach the knobs.Cons: 1: I was not pleased with the knobs, they are very loose on the stems. With the hold down screw not installed, there is about 20 degrees of free rotation on the stems.2: The knobs turn more than a half turn which goes past fully open and begins to restrict flow.3: The knob caps have to be clocked so that its flutes match the flutes on the knob. This requires rotating the H or C label in the cap to be rotated as well to be aligned.Bottom line, cartridges good, knobs bad. I reverted to using the original knobs which resolved all them Cons listed.

Worked perfect, price point is great, would like to see the instructions a little more detailed for the seal on top of the spring. There is a certain way it should go in. However the kit is priced good and does the job

My old Delex faucet was dripping like crazy. This kit did the trick. Like other reviewers have said, it acts a little funny when you turn the faucet all the way on. The flow rate changes a bit in a certain position, which is not really an issue for me. It was easy to install with a crescent wrench, screw driver, and pliers. The packaging was a bit flimsy as some of the parts were loose in the Amazon box, but no damage.

They're smaller than the original but serve the function. Satisfied with them. Easy with the kit.

I had a very small dripping leak on my Delta/Delex Laundry Tap.. the Hot side. This kit fit like a glove, was a fast install, and NO leaks! The price for 2 cartridges, springs, seats, and handles was $4 more than ONE replacement cartridge at my local hardware store! And these cartridges have metal stems! I now have a spare part on hand for the next leak down the road!

Me gustaron mucho y quedaron perfectas, llegaron rapido

good price

These taps came with a set of valves. Everything was decent quality and was easy to install. The screws were decent quality. Allowed me to replace a broken knob without having to replace entire faucet at this time. This set got the job done.

It's really hard to get the right faucet buttons [hot and cold] for older existing faucets. This faucet replacement set had the knobs and buttons too...worked really well. My husband just replaced the entire knobs and voila I had the new buttons in place. This was a reasonably priced solution to my problem of a missing and cracked button.