GlowShiftUniversal Black Triple Pillar Gauge Pod - Fits Any Make/Model - ABS Plastic - Mounts (3) 2-1/16" (52mm) Gauges to Vehicle's A-Pillar

Fit just fine on my 1992 firebird. Only thing I would improve on with this product is to have Pre-drilled holes to put the screws through.

Easy to install

Got this for my 2011 Nissan Juke. The cost is very reasonable and with some work I believe you could fit this to virtually any vehicle. If you are not confident of using a heat gun to mold a product I would still recommend this product, but advise you to not expect results greater than what you can provide. It does work well and the look is what I was expecting and it didn't cost me over $200.00. I now have three gauges (Oil Temperature, Oil Pressure and Turbo boost) to monitor my engines performance, where I had none before. Gauges do not come with the item.

Had to put holes in my a pillar because it came with no mounting hardware or anything but it was decent for the price. Whats important is that my 52mm aem uego and prosport oil pressure gauge fit very snug and perfect. Had to diy a way to mount it in mybe36 but if youre looking fof a cost effective solution without too much loss in quality, get this one.

Isnt shaped right to hug pillar, no hardware for mounting. Not sure what the extensive foam is for either.

I ordered this product during a custom gauge installation that I was doing on my 1993 Honda Del Sol, and was quite skeptical of how it would fit on my door post since it is a "universal fit" after all, and you know how that can be. But when it came and I test fitted it, I was amazed at how closely it matched the contour of my Sol's door post. The angle at which the gauges look at you is perfect and it fits almost perfectly on the length of the post. The arch is slightly more than the Del Sol's post, but I filled the gap with some of the insulating foam that came with the product and it is a perfect fit for my car. I liked this product so much that I just ordered another one to go on the passenger side door panel. I can't say that it would fit this good on every car, but on mine it sure did. I hope this helps those with a similar situation to mine!

Great value for the $$. Like others have said, I had to remove the windshield trim, and use a heat gun to mold it around the trim. I'm guessing that this would fit many vehicles, if the same process was used. I am happy with my purchase, and the pillar compliments my 99 Ranger 302 swap well. Thank you! 👍

Fast delivery and perfect fit