Lantee 10 Pcs Engine Cover Clips Fender Liner Fasteners Replace for Subaru 90913-0067

I needed a couple of them for my 2003 Subaru Baja. They fit fine now I have several more on hand if I should need them.

Cheap, not long enough and most broke.

I bought them for my Subaru Baja as a few were missing with age. Fit like a glove.

Great product

Great SellerProduct as advertised

They work: and there are plenty

worked great

These are a waste of money. Like a previous reviewer said, they are garbage. The clips a too big for the holes. To install them is virtually impossible and if you do manage to get them in, they cant be removed without destroying them, So disappointed, I had such high hopes to get my engine bay looking like new again. Terrible waste.

It seems like i cannot unlock the head screw from the stemi use it on my engine and i cant take it off because of the head screw the tiny part that sits on the steam to push the head is way too small you cant even fit a screw driver inside the push clip so you have to ruin everything or worsts case scenario is to drill it it is onetime use only. Its an immitation of OEM push clips of subaru.

The pin diameter is ok, about 8mm.The rotating head is completely useless; it doesn't pop out when rotated so you can't remove these easily once installedOn the OEM parts and the picture, there are tabs and ramps that make the head pop-out when rotated. On the parts I received they're too small and the head doesn't pop enough to insert a tool under it.

I specifically ordered this version because I like the type where you can unlock the clip with a phillips screwdriver. However, with this product, it does not unlock because the bumps to pull the plug out far enough to unlock it are too small and therefore you cannot unlock it with a screwdriver. What is worse is that because the cap of the pin sits inside the outer rim of the clip, you can't even get a screwdriver in there. What is worse is that after two emails to their support line I got no response.

Clips are the same size as the OEM clips on my 2010 Impreza STi, but aren't as functional. They pop into place but do not pop out when un-screwed. This makes them a more permanent replacement, as they can not be easily removed once inserted. As far as I can see, the only way to get them back out again is to pry with a sharp knife or very thin screwdriver around the edges, and even then you may have to resort to breaking them to get them out.I'd recommend looking elsewhere for replacement clips.

The diameter is pretty spot on, fits in place of older rivets, but is impossible to remove once installed.The inner part has a philips head leading you to believe you can turn the head to remove it but the center part doesn't actually have any threads or ramps so it just spins in place. There's no gap either along the head to fit a pry tool into.Only plus is that there's 50 so if you're ok with destroying them upon removal and installing new ones, there's plenty in the kit to do so.