Cable Grip Strip Floor Cable Cover Protect Cords Cable Protector Cable Management 4”Width x 10’Length - Black Only for Commercial Office Carpet

Good quality and same as it was advertised. It adhesivness to the carpet is really good and we used it to cover a thick wire in our office and it worked well. I am very satisfied by this purchase.

It's a bit stiff, so laying it down takes some work to work out the wrinkles, but it isn't that bad. Grips great, is fantastic. And we have a LOT of cabling going through it. I think we're pushing it to its limits. But we love it!

When I purchased this I was reluctant not knowing exactly what it was. I ordered it instead of the "rubber" type floor cable cover. It was easy to cut and I must admit I was still skeptical since the material is so thin, but when I applied it over the cables to the carpet I was pleased. It turns out that when you vacuum this doesn't get in the way like the rubber/plastic ones do. It rolls right over the cables. I would buy it again.

Good for low profile carpet, not work on thick carpet.

I have been trying to find a super easy-to-use and durable cable grip and I have found it!! It was super easy to cut, apply to the carpet and reapply if and when needed. I used it for my extension cords in my office and I absolutely love it. I like how easy it is to remove and readjust it without damaging the carpets, plus you can cut it to any length you need which was super nice as well. It is wide enough to fit multiple thin cords under it, or at least 2 thicker cords under it. It never came up off of the carpet on its own and stuck very well. If you are looking for a durable product to hide/hold down cords then this is the product for you my friends.

This is very cheaply designed. Very flimsy and the Velcro does not hold on carpet.

Use these at work to keep cables from being tripped over. Reusable is a plus.

Product does NOT stick to tight pile office carpet at all. I'm not sure it would stick on shag either. I'm not clear exactly how "loose" your carpet pile would need to be but the high wear type of very low/tight pile carpet we have in our office provides ZERO adhesion. Otherwise, it's about 4 inches wide thin nylon tight fabric, think super thin backpack fabric. the fabric seems like you could vacuum over it (if it stuck) without trouble. The Velcro loops appear to be too short and tight to grip office carpet. I think the loops may have been designed to grab the customary other "shaggy" side of the usual two sided Velcro system and not designed for carpet at all. I think this wouldn't grip well unless you have exactly the texture of the "shaggy" side of a Velcro system. Packaging was fine, it just doesn't work as intended.