OTUAYAUTO 100PCS Plastic Rivet Clip, Replacement for Jeep Wrangler 07-23, Chrysler 300 99-10, Dodge Avenger 08-14, Nylon Fastener Replace OEM:10184895 6506007AA 6501559 N803862-S

These clips were very much needed to replace my broken OEM clips. Very happy to find these! The price is awesome and the quality is as good or better than the OEM clips.

Purchased these to reinstall my daughters bumper after I did some body work on it. they fit very well and hold the bumper securely.

plastic is a little brittle. rivets need a rivet gun a hair larger than a normal 1/8th. you just need to use a wench to hold the rivet in the hole and pilers to pull the stem over the wench. so far the fender is tight.

no issue bought to use on grill of a 2013 jeep wrangler Not as sturdy as oem ones but worked just the same not complaint

These work every time. Clean break, solid hold. Thank you.

Accesorio conforme a su presentación y funcional

It fit and worked great thank you

I put off buying a tool because it looked like one was included. Apparently not. Other than that, they seem to be okay.

Necesarias para mantener en buen estado los vehículos

Otuayauto plastic rivets QGZ024I don't put a lot of faith in product reviews any more because all too often the product hasn't been given a serious test, or is a result of a sellers "bribe". This product is an exception and deserves the following review.I used the rivets when I replaced the plastic left front inner fender liner on my 2001 Dodge 2500 4x4. They are a direct replacement for the same thing that Chrysler demands an obscene amount of money for. Getting the old rivets out is easy. I just used a 5/32" pin punch to drive them back from the head end. There is a tool available for installation but as long as you have some reasonable working room around the rivet head you don't need it. I just used a pair of vice grips and a Cat Claw (body man's upholstery tool).First I pre-formed the rivet arms by clamping my Cat Claw in a vice and used the vice grips to carefully pull on the locking rod until the arms were extended. Be careful not to pull the rod far enough to engage the locking serrations. If you do, I think you can push the rod back without doing any harm. By pre forming the arms it makes it a lot easier to extend them when in place.To install them just get the liner in the right position and start wherever you think is best. Push the pre-formed rivet into the hole in the liner and into the hole in the inner fender. Using the Cat Claw put as much force as you can on the rivet head to keep it and the liner tight to the inner fender. Then clamp the vice grip on the locking rod and pull it out until you can feel and hear the serrations on the rod engaging with those of the rivet head. When you have all the rivets installed just go around with a pair of small side cutters and nip the rods off at the head.This product is reasonably priced and works as advertised. Top marks .

Ideal para los trabajos de mantenimiento en casa.. y volver a dejar todo tal y como debe de estar en el carro.

Très bien pour mon jeep cela fait là job.

Es difícil poder ponerlos todos debido a que se salen, parece que no hace la suficiente presión. Tuve que comprar otros de diferente diseño.