RGBZONE 4Pcs ES08MA II 12g Mini Metal Gear Analog Servo Shockproof Stable Machine Compatible for RC Model

excellent article.... and to fast delivered

I have used these is some rc builds and regardless of vehicle type they are strong and reliable. I have installed these in a monster truck, shortcut car, a boat and one on a airplane and have had no troubles so far.

happy

Excelente producto

Replacement for plastic gear servos, very reliable, and affordable.

These are not EMAX servos as advertised. You can see the difference in the photos by the stickers. Different fonts, colors and horrible placement. Even plugged one in to try it and they are WAY worse than factory servos. Super noisy and hardly any torque to them.

Buyer beware, these mention nothing in the add about being an Emax servo yet they have placed a label on the servo calling it an Emax servo. I did not purchase these expecting them to be the real deal, I just needed some cheap servos for a cheap project I have going. What I didn't expect was to receive servos that are branding themselves as an Emax. The logo is incorrect, these are clearly not real Emax servos and are knockoffs. IF you notice the E with the red stretched out block to the left, that is the fake way of labeling them. The real servo also has a trademark symbol in the lower right corner. I have the same authentic Emax servo and these are slightly bigger. Photos are of the knockoff.Anybody claiming in the reviews to be the real deal are being fooled.

Perfect servos for the perfect price. I dont take them under water

Great little servo’s for light balsa and foam model RC planes.

After using the plastic-gear 9g version of these motors, I had quite a bit of trouble figuring these out.In the end, it turned out to be mainly my fault. The main issue I had, was trying to figure out how to properly use them. With my previous electronic setup, I found that when I issued movements to the servo, it would work at first, and then it would spin indefinitely (and would refuse to listen to any PWM commands).This confused me for two reasons: 1) I didn't understand why the motor was not listening to the PWM any more and 2) I didn't understand how the servo was continuously spinning in one direction (despite seeming to not be a continuous motor).Turns out the following:What was happening was that my power supply was fairly bad, and thus, when using these beefier servos, the power supply could not keep up. This, I assume was causing the servo to crash, stop reading the PWM signal.I read reviews of other Servos that advertised "continuous 360 rotation when powered off" so that tells me this motor is probably something similar.I also read another comment from someone saying that continuous motors have a tendency to continue doing the last received command.So in my case, I think what was happening was the following:The servo was given a signal to move to a position.The microchip would crash and stop reading the PWM.The microchip loses connection to the PWM and defaults to continue what it was doing before (moving). And thus, the servo doesn't stop spinning.Anywho, once I swapped out the power supply, I didn't have the same problem.I noticed someone else in the reviews mention this spinning behaviour, so hopefully, this is helpful to someone.

None of these items worked. 100% defective.

I gave 4 stars because these are re-brands. That being said , I cannot tell the difference from the real emax. The work extremely well, no play, and are very quiet. I will buy again

i grabbed these to replace my shift servo on my scx10iii. they seem to work good for that.