Stainless Steel Rivet Nuts Threaded Insert Nutsert Rivnuts 5 Sizes 8-32, 10-24, 1/4"-20, 5/16"-18, 3/8"-16

Very good product, easy to set

They work. They’re sturdy and worked well with the Rivnut gun I bought.

great to have on hand. stainless means no rust. fun to work with

It worked fine for what I was using it for. I just wish I would’ve had a good installer.

Excellent product great service

Hope your patient! It took almost 3 weeks from order to receipt. Great item, especially in stainless steel but I hope your not in a hurry.

I used these to replace some failing fasteners holding the mirrors on my service truck. Installed cleanly, threads seem good, they are holding tight in the sheet metal panel and have not rusted after a few months in the weather. That's not the most strenuous test, but so far so good. Used a few on other miscellaneous projects too. The case is nice to keep things organized and will actually stay latched shut. You probably have experienced cheap little cases of fasteners that pop open at the worst times; sometimes the smallest things can be the biggest headaches. These rivnuts have been a good value and I would definitely buy them again.

Only used 5 so far, one to test if my tool could handle stainless steel. Then used 4 Rivnuts to mount a towel rack on an aluminum wall. Worked well. I think my Rivnut tool is only rated for 8/32, maybe 10/32 Steel Rivnuts. Larger Aluminum Rivnuts, no problem. It takes a heavy duty tool to put in steel or stainless steel Rivnuts. If you don't have a tool I have used a grade 5 bolt, a few washers to allow things to slip, a "regular nut with the threads drilled out" and a long nut. Setup --- Note --- A threaded rod works too, with a double nut tightened together in place of a bolt 1. Place the “threaded long nut” on the bolt first. 2. Then a couple washes 3. Then the “nut with the threads drilled out” 4. Then a nice tight fitting washer 5. Then the Rivnut. How to install Rivnut --- Try a test run for good luck I forgot to tell you this is where you may need your third hand to keep the Rivnut from turning. 1. First wrench -- Holds the bolt from turning 2. Second wrench -- Turn the “Threaded long nut” 3. Third wrench -- Now using your third hand Hold the “nut with the threads drilled out from turning and spinning the Rivnut as you tighten the system.

My husband was very happy. He needed the stainless steel for an outside project where we get lots of rain. Building a roof over the BBQ deck.

Solar panel brackets

Good value.

Does the job, just a little spendy.

These things are awesome