Schlage Available Lock SC990B-716 Sliding Door Pull, Age, Aged Bronze

Fits & less expensive than the box hardware

It looks great and the quality is well worth it for the price. Very happy once it's installed. Installation was pretty easy on a new slab. I installed mine after the door was installed so that made it a luttlecmore difficult but not bad. I highly recommend using a coping saw for this. If the slab is laid down then a jigsaw should work as well.My only complaint is that there needs to be more of a lip on the top one bottom of the latch to hide the cut edge of the cutout. The sides do this very well. I realize that they made it this way to fit flush with the door jamb but I don't know of many pocket doors (esp the non locking ones) where one would care about a very thin gap thus would cause.Again, happy with it overall and would buy again. Just take your time and don't cut the hole any larger than you have to. I cut slightly smaller and the sanded until it was a tight fit (gently used a rubber mallet).

Replaced a broken 43 year old pocket door pull.

These pair well with our existing Schlage oil rubbed bronze door hardware. Very easy to install!

Great for pocket door but inside pulley breaks easily

I found this handle to be of good quality.It has a nice finish which didn't exactly match most of my other door handles, but that was to be expected as those were made by another manufacturer (Kwikset) and the difference is not so much that it matters to me.My installation was on a new slab for a pocket door which had not yet been cut for a handle. With that said, I found installation to be easy and simple. Measurements are provided on the package and as long as you can measure and are comfortable using a saw (or maybe a router) to cut the notch, there should be little issue. If you are ordering this as a replacement for an existing handle, then it should be even easier. Just a couple if screws.Once installed the handle looks great and the pI'll lever that pops up works very well. It's easy to pop out, stays out while you're usin it and the falls back into place pretty easily.

If you need a locking pull for a pocket door there's not many options in the aftermarket, so this will do the job. However don't expect it to fit nearly as well as the handles that are installed on some doors. It also feels like a thinner, cheaper metal than many of the handles I've seen in stores that aren't locking.

Exactly what I was looking for

Use to update my house

looks good

Parfais

Good looking install easy

It worked great for a replacement.