ACS445 Adaptive Cutting System Guide Track Connectors | Guide Track Connectors for Joining Adaptive Cutting System Tracks Into Longer Cutting Lengths

Each one is two pieces with the set screws pushing the pieces apart. This way the set screws don't damage the tracks and there is much more surface area friction. They work well.

Did exactly what they were designed to do.

Works well just what I wanted

The product design does a great job of tightly holding the tracks together and square, while not placing a localized stress that could damage either track. If you're using the track saw to break down sheets of plywood, it's only a matter of when you'll need multiple tracks and these connectors. I've compared my Kreg ACS track to Festool and Makita and they are not compatible.

I used these to connect two Accu-cut base systems, no one had the XL version locally and I needed it that day. Keegan will tell you it doesn’t work but it did for me.

Kreg Adaptive Cutting System is what it is advertised as. I recommend this system to anyone that works with wood.

Works as it should

For the price every one wants from Kreg for 4 small strips of steel, 8 tiny set screws and an Allen wrench you would think they could make and ship them straight. The thinner bars with the single tapped hole were straight. The heavier bars with the four tapped hoies were "S" bent to a straight edge. Tried them as made and shipped and took tracks out of flat on steel machine table. Took 10 minutes to tap them straight using drilling hammer, ground steel anvil and machinist straight edge. Then track sat dead flat. small issue but for the price they should be right. Some/most people might not notice or care.