O-Cedar Replacement Handle, 1 Count (Pack of 1)

This spin mop is definitely a cool idea. And it works just as intended. However, the entire concept rests on this handle.If you're looking at this handle, then you probably already have a spin mop. And know how it works.If not, to operate, you will insert the mop head (which is attached to this handle) into the spinning chamber in the filled bucket. Then, loosely hold the handle in your hand (allowing enough room around it so it can move freely, but securely enough to prevent it from falling out of your hand). Now, pump the lever on the bucket with your foot to spin out the mop. This parts works great. And your mop will spin nearly dry (or any degree of wetness in between).However, there's no brake to stop the spin. So you must either wait for it to stop spinning on its own or use the handle as a brake by tightening your hand around it as it spins. And if if you squeeze too tight (causing the mop to abruptly stop), you will place a lot of torque on the part of the handle that screws into the mop head. Over time, this part will weaken (it's only plastic) & eventually break off into the mop head.Which is the reason they sell replacement handles :-(.If the manufacturer were to use a metal threading at end of the pole instead of plastic, this may solve this issue. Until then, be glad they sell replacement poles!

It works and fit perfectly.... beats buying a whole new mop kit.

Works as it should

I ordered this because my other one didn't stay on when it was spinning. Neither will it stay on with either handle while spinning

My previous mop had broken I was able to use my mopping system again without repur having the entire set

I'm only 5 4 and it seems a little short for me. I like that it's compact tho.

Handle is good.

You have to use Thread Seal Tape to use this. Is not the perfect fit….

Is still a little bit short but works fine

Necesario

Cumple lo prometido